Equipment List for N4742E
Equipment List for Cessna A185F N4742E s/n 185-03853
Aircraft Frame TT: 2019hrs.
Engine:
TCM IO-520-D TCM Factry remanufactured Installed in January 1992. TTSN 780
GAMI tuned Injectors
Brackett Air Filter Kit
EZ-Heat Engine Pre-heater system
6-Cyl EGT sender/display
Prop: Hartzell 80” F8468A-6R 3-blade prop installed in 1995. Two small minor nicks dressed out. TTSN: 715
Floats:
AeroSet 3400 Hydraulic Amphibious Floats installed in 2004. No damage. TTSN: 10 hrs
Skis:
Airglide Fluidyne 3200 Hydraulic Wheel penetration skis. Modified with Teflon bottoms and stainless steel skags.
Airframe TTSN: 2019 hrs.
Sportsman Leading Edge STOL kit
Vortex Generators
Amphib kit from factory
Tail wheel Lock
XP Mods heavy duty tailwheel
Fresh Paint in 2000
New Interior Seating, Headliner and Panels in 2000
P-Ponk Landing Gear modification
One-piece windshield
Panel:
Full IFR with vacuum and electric attitude instruments.
Avion Research Control Yokes with A/P, trim, com controls.
S-Tec 30 3 axis auto pilot with GPSS coupled to Garmin 430.
6 cylinder EGT
King Transponder
King ADF
King KX155 Nav/Comm
King Audio Panel
Garmin 430 GPS/Comm
6-place PS Engineering intercom w/ stereo inputs
Interior:
New upholstery 2000
New Headliner 2000
New trim panels 2000
BAS Inertia shoulder reels/harness
Aircraft Frame TT: 2019hrs.
Engine:
TCM IO-520-D TCM Factry remanufactured Installed in January 1992. TTSN 780
GAMI tuned Injectors
Brackett Air Filter Kit
EZ-Heat Engine Pre-heater system
6-Cyl EGT sender/display
Prop: Hartzell 80” F8468A-6R 3-blade prop installed in 1995. Two small minor nicks dressed out. TTSN: 715
Floats:
AeroSet 3400 Hydraulic Amphibious Floats installed in 2004. No damage. TTSN: 10 hrs
Skis:
Airglide Fluidyne 3200 Hydraulic Wheel penetration skis. Modified with Teflon bottoms and stainless steel skags.
Airframe TTSN: 2019 hrs.
Sportsman Leading Edge STOL kit
Vortex Generators
Amphib kit from factory
Tail wheel Lock
XP Mods heavy duty tailwheel
Fresh Paint in 2000
New Interior Seating, Headliner and Panels in 2000
P-Ponk Landing Gear modification
One-piece windshield
Panel:
Full IFR with vacuum and electric attitude instruments.
Avion Research Control Yokes with A/P, trim, com controls.
S-Tec 30 3 axis auto pilot with GPSS coupled to Garmin 430.
6 cylinder EGT
King Transponder
King ADF
King KX155 Nav/Comm
King Audio Panel
Garmin 430 GPS/Comm
6-place PS Engineering intercom w/ stereo inputs
Interior:
New upholstery 2000
New Headliner 2000
New trim panels 2000
BAS Inertia shoulder reels/harness
Owner History of N4742E
Ownership History for Cessna C185F N4742E s/n 18503853
From Cessna Aircraft:
Date Sold to:
06/18/79 Avico North, Ltd. – Madison WI
06/18/79 Wood City Aero Service – Cloquet MN
06/22/79 William Willcutts – Longmont CO
07/17/80 Alaska Western, Inc (William Willcutts-pres) – Anchorage AK
11/01/84 R&M Consultants – Bob Dortch, VP – Anchorage AK
12/12/88 Thomas McGuire – Anchorage AK
01/03/91 Wings of Hope, Inc (Thos. McGuire, Pres.) – Chesterfield MO
01/05/94 Michael Katz – Fullerton ND
04/20/98 Boundary Water Air (Floyd Gutowski, Pres.) – Eveleth MN
05/19/98 Rule 12. LLC (Dave West – Owner) – Bloomer, WI
From Cessna Aircraft:
Date Sold to:
06/18/79 Avico North, Ltd. – Madison WI
06/18/79 Wood City Aero Service – Cloquet MN
06/22/79 William Willcutts – Longmont CO
07/17/80 Alaska Western, Inc (William Willcutts-pres) – Anchorage AK
11/01/84 R&M Consultants – Bob Dortch, VP – Anchorage AK
12/12/88 Thomas McGuire – Anchorage AK
01/03/91 Wings of Hope, Inc (Thos. McGuire, Pres.) – Chesterfield MO
01/05/94 Michael Katz – Fullerton ND
04/20/98 Boundary Water Air (Floyd Gutowski, Pres.) – Eveleth MN
05/19/98 Rule 12. LLC (Dave West – Owner) – Bloomer, WI
Airworthiness Entries for N4742E
Build, modifications, additions and damage history on FAA records for
Cessna A185F N4742E s/n 185-03853
Engine: TCM IO-520-D Prop: McCauley D2A34C58/90AT-4
6-23-79 Standard airworthiness certificate issued to Cessna Aircraft.
11-13-79 Bounced Landing by William Willcutts in Greeley CO with resulting damage to gear.
8-28-80 Install Aqua 180-185 floats per STC SA35599 by Brain Gillette – Anchorage AK.
6-30-87 Install Apollo 604 Loran Radio & Antenna by Northern Lights Avionics – Anchorage Ak.
07-11-88 Upset in high winds during water landing resulting in nose over and damage to wings. Anchorage AK
01-04-89 Repair Left & Rt wing and ailerons by Geoffrey D Hanes – Big Lake AK.
05-01-90 Install Aqua 180-185 floats per STC SA328CE by Paul Erickson – Anchorage AK
09-09-92 Install Alcor MCCA 6-cyl EGT per STC SA522SW
Install Cleveland Wheel kit 199-06203 per STC SA63GL
Install Rapco Oil Filler Tube Extension per STC SE938DL
Install Fuel Vapor return line. All done by Ed Schertz – Chesterfield MO.
06-05-92 Replace RH Lwr Engine Mount tube
Install Finger Patch Doublers to front engine mount cross tube. All done by James Hayton, Sedro Wooley WA.
09-09-92 Install two temp fuel/oil ferry tanks to interior. Done by Ed Schertz – Chesterfield MO.
09-17-92 Special Ferry Permit to operate aircraft in overweight condition from St. Louis to Indonesia.
12/02/92 Special Ferry Permit to operate aircraft in overweight condition from St. Louis to Indonesia (Previous permit dated 9/17/92 expired).
12/12/92 Forced landing in Lani HI due to engine power failure in field with dirt berms. Aircraft determined to be damaged , but airworthy by FAA inspector and allowed to continue on ferry permit.
11-05-95 Replace various skins, bulkheads, stringers, door sills to cabin area of aircraft as result of forced landing in rough field
Install Bracket Air Filter per STC SA71GL
Install one-piece windshield by LP AeroPlastics per STC SA4741NM.
Install 80” Hartzell 3-blade prop HC-C3YF-1RF/F8468-8R per STC SA1443NM.
Remove Ferry Tanks from aircraft interior. All work done by Paul Sanders – Fairmont MN.
05-18-98 Remove tailwheel assy. Replace with XP Mods #XPM1-6 assy. Done by Bradley Forseen – Mt. Iron MN
02-08-99 Remove ELT and replace with new ELT model ACK Tech E-01 by Rich Schroeder – Menomonie WI.
07-07-0 Replace two lower fuselage bulkheads and aft LH landing gear support bracket. Done by John Blackhurst – Tower MN.
04-23-01 Replace stock injectors with GAMI injectors per STC SE 09217SC by Rich Welch – Menomonie WI
04-27-01 Install BAS restraint system per STC SA2067NM
Install S-Tec System 30/Alt/GPSS autopilot per STC SA09270AC-D
Install Avion Research Control Yokes per STC SA00709LA
Remove Garmin G100AVD & Antenna
Install Garmin GNS 430 GPS/NAV/Com & Antenna
All work done by Rich Welch – Menominee – WI
08-31-04 Installed Aeroset Amphibious Float system model 3400 including hydraulics and annunciator per STC SA01257.
Installed Flite Research ‘Sportsman’ STOL leading edge kit per STC SA2256WE.
Installed ATS Vortex Generator Kit per STC SA00165SE. Work performed by William Thomas (Hartland Aviation) – Eau Claire WI.
Cessna A185F N4742E s/n 185-03853
Engine: TCM IO-520-D Prop: McCauley D2A34C58/90AT-4
6-23-79 Standard airworthiness certificate issued to Cessna Aircraft.
11-13-79 Bounced Landing by William Willcutts in Greeley CO with resulting damage to gear.
8-28-80 Install Aqua 180-185 floats per STC SA35599 by Brain Gillette – Anchorage AK.
6-30-87 Install Apollo 604 Loran Radio & Antenna by Northern Lights Avionics – Anchorage Ak.
07-11-88 Upset in high winds during water landing resulting in nose over and damage to wings. Anchorage AK
01-04-89 Repair Left & Rt wing and ailerons by Geoffrey D Hanes – Big Lake AK.
05-01-90 Install Aqua 180-185 floats per STC SA328CE by Paul Erickson – Anchorage AK
09-09-92 Install Alcor MCCA 6-cyl EGT per STC SA522SW
Install Cleveland Wheel kit 199-06203 per STC SA63GL
Install Rapco Oil Filler Tube Extension per STC SE938DL
Install Fuel Vapor return line. All done by Ed Schertz – Chesterfield MO.
06-05-92 Replace RH Lwr Engine Mount tube
Install Finger Patch Doublers to front engine mount cross tube. All done by James Hayton, Sedro Wooley WA.
09-09-92 Install two temp fuel/oil ferry tanks to interior. Done by Ed Schertz – Chesterfield MO.
09-17-92 Special Ferry Permit to operate aircraft in overweight condition from St. Louis to Indonesia.
12/02/92 Special Ferry Permit to operate aircraft in overweight condition from St. Louis to Indonesia (Previous permit dated 9/17/92 expired).
12/12/92 Forced landing in Lani HI due to engine power failure in field with dirt berms. Aircraft determined to be damaged , but airworthy by FAA inspector and allowed to continue on ferry permit.
11-05-95 Replace various skins, bulkheads, stringers, door sills to cabin area of aircraft as result of forced landing in rough field
Install Bracket Air Filter per STC SA71GL
Install one-piece windshield by LP AeroPlastics per STC SA4741NM.
Install 80” Hartzell 3-blade prop HC-C3YF-1RF/F8468-8R per STC SA1443NM.
Remove Ferry Tanks from aircraft interior. All work done by Paul Sanders – Fairmont MN.
05-18-98 Remove tailwheel assy. Replace with XP Mods #XPM1-6 assy. Done by Bradley Forseen – Mt. Iron MN
02-08-99 Remove ELT and replace with new ELT model ACK Tech E-01 by Rich Schroeder – Menomonie WI.
07-07-0 Replace two lower fuselage bulkheads and aft LH landing gear support bracket. Done by John Blackhurst – Tower MN.
04-23-01 Replace stock injectors with GAMI injectors per STC SE 09217SC by Rich Welch – Menomonie WI
04-27-01 Install BAS restraint system per STC SA2067NM
Install S-Tec System 30/Alt/GPSS autopilot per STC SA09270AC-D
Install Avion Research Control Yokes per STC SA00709LA
Remove Garmin G100AVD & Antenna
Install Garmin GNS 430 GPS/NAV/Com & Antenna
All work done by Rich Welch – Menominee – WI
08-31-04 Installed Aeroset Amphibious Float system model 3400 including hydraulics and annunciator per STC SA01257.
Installed Flite Research ‘Sportsman’ STOL leading edge kit per STC SA2256WE.
Installed ATS Vortex Generator Kit per STC SA00165SE. Work performed by William Thomas (Hartland Aviation) – Eau Claire WI.